Specifications

10. Connect the drive cables:

a. Connect the power cable (1) and data cable (2) to the hard drive.

Figure 5-50 Removing the optical drive

b. Route the SATA and power cables through the cable guide on the bottom of the chassis

frame behind the hard drive. (See

Cable management on page 96.)

c. If the system has only one SATA hard drive, the data cable must be connected to the dark

blue connector labeled SATA0 on the system board to avoid any hard drive performance

problems. (See

Locate system board drive connections on page 71.)

11. Rotate the drive cage and the power supply down to their normal positions.

12. Replace the front bezel (see

Installing the front bezel on page 65).

13. Replace the access panel (see

Installing the access panel on page 64).

14. Restore all connections and equipment that you removed during the

Predisassembly procedures

on page 62.

ENWW

Removing and installing components