Specifications

CAUTION: Insert or remove the carrier (with a disk drive) only when the workstation is shut
down. Other procedures may result in system hangs, data loss, or even drive damage. The
component supplier’s user guide describes a procedure for inserting or removing the carrier (with
drive) while the workstation is booted and then powering the drive via the power switch on the
enclosure. However, Microsoft Windows XP and Windows Vista do not support this action.
a. Insert the key (1) and turn it clockwise (2).
Figure 5-43 Locking the carrier
b. Press the handle to open the door (3).
c. Insert the drive carrier.
d. Lock the carrier by inserting the key and turning it counterclockwise (3).
CAUTION: Always lock the drive before shipping or moving the computer. Failure to do so
might result in damage to your removable hard drive system.
12. Replace the access panel (see Installing the access panel on page 64).
13. Restore all connections and equipment that you removed during the
Predisassembly procedures
on page 62.
Removing and replacing the primary hard drive
The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the
hard drive:
1. Follow the procedures listed in the
Predisassembly for drives on page 69 section.
CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or
data loss.
2. Remove the access panel (see Removing the access panel on page 64).
3. Remove the front bezel (see
Removing the front bezel on page 65).
ENWW
Removing and installing components
91