Service Reference Guide

Service Reference Guide 7–7
Identifying the Chassis, Routine Care, and Disassembly Preparation
7.4.2 Tools and Software Requirements
To service the computer, you need the following:
■ Torx T-15 screwdriver (Compaq screwdriver with bits, PN 161946-001)
■ Torx T-15 screwdriver with small diameter shank (for certain front bezel removal)
■ Flat-bladed screwdriver (may sometimes be used in place of the Torx screwdriver)
■ Diagnostics software
■ Compaq tamper-resistant T-15 wrench (Smart Cover FailSafe Key, PN 166527-001) or
Compaq tamper-resistant bits (Smart Cover FailSafe Key, PN 166527-002)
7.4.3 Screws
The screws used in the computer are not interchangeable. They may have standard or metric
threads and may be of different lengths. If an incorrect screw is used during the reassembly
process, it can damage the unit. HP strongly recommends that all screws removed during
disassembly be kept with the part that was removed, then returned to their proper locations.
✎
Metric screws have a black finish.
U.S. screws have a silver finish.
✎
As each subassembly is removed from the computer, it should be placed away from the work
area to prevent damage.
7.4.4 Cables and Connectors
Most cables used throughout the unit are flat, flexible cables. These cables must be handled with
care to avoid damage. Apply only the tension required to seat or unseat the cables during
insertion or removal from the connector. Handle cables by the connector whenever possible. In
all cases, avoid bending or twisting the cables, and ensure that the cables are routed in such a way
that they cannot be caught or snagged by parts being removed or replaced.
Ä
CAUTION: When servicing this computer, ensure that cables are placed in their proper location during
the reassembly process. Improper cable placement can damage the computer.