Service Reference Guide

5–4 Service Reference Guide
SCSI Devices
5.5 Jumpers
The specifications included below are the standard drive configurations.
5.5.1 Ultra3 SCSI Hard Drive
✎
1. Drive intended only for non-pluggable applications. Migration to a
hot-pluggable drive tray is not supported.
2. All jumper and switch settings shown in the factory default setting, including
those not labeled.
3. Termination is disabled/removed.
SCSI ID Settings
SCSI ID Bit 2 Bit 1 Bit 0
0
1jumper
2jumper
3 jumper jumper
4jumper
5jumper jumper
6 jumper jumper
Default Settings
Signal Description Jumper
S Start unit command
enabled
P Parity enabled jumper
W Write protect disabled
X Switch data transfer
enabled
jumper