Service Reference Guide

2–8 Service Reference Guide
Setup Utilities and Diagnostic Features
Security
(continued)
System IDs Allows you to set Asset Tag and Ownership Tag.
Allows setting of Chassis Serial Number if current number is
invalid.
Also allows you to set keyboard locale setting (e.g., English or
German) for System ID entry.
Allows setting of Ownership Tag and Universal Unique
Identifier (UUID).
See Section 3.4, “Asset Tracking and Security,” for more
information.
Power Energy Saver Allows you to set energy saver mode to Advanced, Disabled, or
Minimal.
✎
In the minimal energy saver mode setting, the hard drive and
system do not go into energy saver mode, but the setting
allows you to press the power button to suspend the
system.This option does not apply under ACPI-enabled
operating systems.
Timeouts Allows you to enable/disable or manually select timeout values.
✎
This selection will appear only when energy saver mode is
set to advanced.This option does not apply under
ACPI-enabled operating systems.
Energy Saver
Options
Allows you to set power button configuration (on/off or
sleep/wakeup.)
Allows user to enable/disable power LED blink in suspend
mode.
✎
This selection will appear only if the energy saver mode is
enabled. This option does not apply under ACPI-enabled
operating systems.
Advanced** Power-On
Options
Allows you to set POST mode (QuickBoot or FullBoot every n
days where n = 1 to 30), enables/disables POST messages,
and delay POST.
Enables/disables Safe Post, F9 prompt, F10 prompt, F12
prompt, option ROM prompt, UUID, I/O APIC Mode, USB
Buffer @ Top of Memory, and Hot-Pluggable MB Floppy.
Allows you to select the wakeup boot source (local hard drive or
remote server).
Allows you to select computer state after a power loss
(On or Off).
✎
The suspend/sleep feature of Remote Management cannot
be used if If the computer was turned off using a power strip.
Onboard
Devices
Allows you to set resources for onboard system devices (serial
port, parallel port, diskette controller, etc.).
**These options should be used by advanced users only.
Heading Option Description (Continued)