Service Reference Guide

2–6 Service Reference Guide
Setup Utilities and Diagnostic Features
Storage
(continued)
Options
(continued)
Diskette MBR Validation
Allows you to enable or disable strict validation of the diskette
Master Boot Record (MBR).
✎
If you use a bootable diskette image that you know to be
valid, and it does not boot with Diskette MBR Validation
enabled, you may need to disable this option in order to use
the diskette.
DPS Self-Test Allows you to execute self-tests on IDE hard drives capable of
performing the Drive Protection System (DPS) self-tests.
✎
This selection will only appear when at least one drive
capable of performing the IDE DPS self-tests is attached to the
system.
Controller Order Allows you to specify the order of the attached hard drive
controllers. The first hard drive controller in the order will have
priority in the boot sequence and will be recognized as drive C
(if any devices are attached.
The selection will not appear if all hard drives are attached to
the embedded IDE controllers.
SCSI Narrow
Termination
Allows you to configure SCSI termination on the external SCSI
connector for narrow SCSI drives. The feature should only be
enabled if using a narrow SCSI drive to terminate the external
SCSI channel.
Boot Order Allows you to specify boot order of installed peripheral devices
(such as LS-120 drive, diskette drive, hard drive, SCSI drive,
CD-ROM drive, or DVD-ROM drive).
Security Setup Password Enables setup (administrator) password.
See Section 3.4, “Asset Tracking and Security,” for more
information.
Power-On
Password
Enables power-on password.
See Section 3.4, “Asset Tracking and Security,” for more
information.
Password
Options
Enables/disables network server mode.
Specifies prompting for power-on password.
See Section 3.4, “Asset Tracking and Security,” for more
information.
This selection will appear only if a power-on password is set
and the network server mode is disabled.
Smart Cover Enables/disables Smart Cover Sensor and Cover Lock. (Feature
supported on select models only.)
Lists most recent cover removal. (Feature supported on select
models only.)
See Section 3.4, “Asset Tracking and Security,” for more
information.
Heading Option Description (Continued)