Service Reference Guide

Service Reference Guide C–3
POST Error Messages
207-ECC Corrected
Single Bit Errors in
Memory Socket(s) y,y
2S Single Bit ECC error. Verify proper memory module type.
Try another memory socket.
Replace memory module if problem
persists.
212-Failed Processor None Processor has failed to
initialize.
Reseat the processor in its socket.
If the processor does not respond,
replace it.
213-Incompatible
memory Module in
memory Socket(s)
X,X, X
2S A memory module in
memory socket identified
in the error message is
missing critical SPD
information, or is
incompatible with the
chipset.
Verify proper memory module type.
Try another memory socket.
Replace memory with a module
conforming to the SPD standard.
214-Memory Device
Failure. Error Code: XX
Memory Module
Socket(s):XX
None A specific error has
occurred in a RDRAM
device installed in the
identified socket.
Verify proper memory module type.
Try another memory socket.
Replace memory module if problem
persists.
215-RIMM
Configuration Error
None RIMMs not properly
installed.
Populate RIMM sockets starting with
slot no. 1 and do not leave any
memory sockets empty.
301-Keyboard Error None Keyboard failure. Reconnect keyboard with computer
turned off.
Check connector for bent or missing
pins.
Ensure that none of the keys are
depressed.
Replace keyboard.
304-Keyboard or
System Unit Error
None Keyboard failure. Reconnect the keyboard with
computer turned off.
Ensure that none of the keys are
depressed.
Replace keyboard.
Replace system board.
401-Parallel Port 1
Address Assignment
Conflict
2S IRQ address conflicts
with another device.
Reset the IRQ.
* L = Long, S = Short
POST Error Messages
Screen Message Beeps* Probable Cause Recommended Action