Specifications

System BIOS and Resources
System BIOS
Chapter 448
5. Set switch 2 on the system board to ON. See “System Board Switches”
on page 28.
6. Insert the floppy disk into the floppy disk drive.
7. Reconnect the power cord, and turn on the Workstation.
8. The workstation boots from the floppy disk, then flashes the BIOS.
During the flash process, the screen remains blank. When you hear
one long beep, the recovery process is finished.
9. Turn off the Workstation. Remove the floppy disk from the drive.
Remove the power cord and display cables, and remove the cover. (You
must press the pwoer buttong for 5 seconds to get the systemto power
down.)
10.Set switch 2 back to OFF.
11.Replace the cover, reconnect the power cord, and reboot the
Workstation.