Specifications

Installing or Replacing Parts and Accessories
Graphics Card
Chapter 10 163
Figure 10-12 Removing the Graphics Card Retaining Screw
Installing a Graphics Card
To install a graphics card:
1. If you are replacing an existing card, remove the current card (see
page 162).
2. Unscrew and remove the rear slot panel that corresponds AGP Pro
110 4X connector. The screw you removed is used to retain the
graphics card.
NOTE If you are installing a full-length graphics card, you must remove the
graphics board retaining screw near the front of the chassis as shown
in Figure 10-13.