Command Reference Guide

set port type ap 87
Examples — The following command enables SNMP linkup and
linkdown traps on ports 3 and 4:
WX1200# set port trap 3-4 enable
See Also
 display snmp configuration on page 136
 set ip snmp server on page 152
 set snmp community on page 160
 set snmp profile on page 167
 set snmp notify target on page 162
set port type ap Configures an WX switch port for an MAP access point.
CAUTION: When you set the port type for MAP use, you must specify
the PoE state (enable or disable) of the port. Use the WX switch’s PoE to
power 3Com MAP access points only. If you enable PoE on a port
connected to another device, physical damage to the device can result.
Before configuring a port as an MAP access point port, you must use the
set system countrycode command to set the IEEE 802.11
country-specific regulations on the WX switch. See “set system
countrycode” on page 54.
For an MAP that is indirectly connected to the WX switch through an
intermediate Layer 2 or Layer 3 network, use the
set dap command to
configure a Distributed MAP.
Before changing the port type from ap to wired-auth or from
wired-auth to ap, you must reset the port with the clear port type
command.
Syntax —
set port type ap port-list model {ap2750 | ap3750 |
ap7250 | ap8250 | ap8750 | mp-52 | mp-101 | mp-122 | mp-241 |
mp-252 | mp-262 | mp-341 | mp-352| mp-372}
poe {enable | disable} [radiotype {11a | 11b | 11g}]
 port-list — List of physical ports.
 model {ap2750 | ap3750 | ap7250 | ap8250 | ap8750 | mp-52 |
mp-101 | mp-122 | mp-241 | mp-252 | mp-262 | mp-341 |
mp-352| mp-372} — MAP access point model: