Command Reference Guide

set port preference 85
set port preference Configures a gigabit Ethernet port on a WX4400 to use the RJ-45
(copper) interface, when available, as the active link instead of the fiber
interface.
Syntax —
set port preference port-list rj45
 port-list — List of physical ports. MSS sets the preference on all the
specified ports.
 rj45 — Prefers the copper interface.
Defaults — When both the copper and fiber interfaces of a gigabit
Ethernet port are connected, the GBIC (fiber) interface is the active link.
The RJ-45 (copper) link is unused.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400.
If you set the preference to RJ-45 (copper) on a port that already has an
active fiber link, MSS immediately changes the link to the copper
interface.
Examples — The following command sets the preference of port 2 on a
WX4400 to RJ-45 (copper):
WX4400# set port preference 2 rj45
See Also
 clear port preference on page 64
 display port preference on page 69
set port speed Changes the speed of a port.
Syntax — set port speed port-list {10 | 100 | 1000 | auto}
 port-list — List of physical ports. MSS sets the port speed on all the
specified ports.
 10 — Sets the port speed of a 10/100 Ethernet port to 10 Mbps and
sets the operating mode to full-duplex.