Command Reference Guide

80 CHAPTER 4: PORT COMMANDS
specify the external antenna fitted, use the set {ap | dap} radio
antennatype command.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command configures Distributed MAP 1 for
MAP model AP3750 with serial-ID M9DE48B012F00:
WX4400# set dap 1 serial-id M9DE48B012F00 model ap3750
success: change accepted.
The following command removes Distributed MAP 1:
WX4400# clear dap 1
This will clear specified DAP devices.
Would you like to continue? (y/n) [n]y
See Also
 clear dap on page 62
 clear port type on page 65
 set port type ap on page 87
 set radio-profile 11g-only on page 329
 set system countrycode on page 54
set port Administratively disables or reenables a port.
Syntax — set port {enable | disable} port-list
 enable — Enables the specified ports.
 disable — Disables the specified ports.
 port-list — List of physical ports. MSS disables or reenables all the
specified ports.
Defaults — All ports are enabled.
Access — Enabled.
History — Introduced in MSS Version 3.0.