Command Reference Guide

78 CHAPTER 4: PORT COMMANDS
 dap-num — Number for the Distributed MAP. The range of valid
connection numbers depends on the WX switch model:
 For a WX4400, you can specify a number from 1 to 256.
 For a WX1200, you can specify a number from 1 to 30.
 For a WXR100, you can specify a number from 1 to 8.
 serial-id serial-ID — MAP access point serial ID. The serial ID is
listed on the MAP case. To show the serial ID using the CLI, use the
display version details command.
The serial ID of the AP2750, AP3750, AP7250, AP8250, or AP8750 might
be preceded by 4 digits and a slash (example: 0100/). Do not enter these
digits or the slash.
 model {ap2750 | ap3750 | ap7250 | ap8250 | ap8750 | mp-52 |
mp-101 | mp-122 | mp-241 | mp-252 | mp-262 | mp-341 |
mp-352 | mp-372}
— MAP access point model:
 ap2750 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g. An external dual-mode
antenna may be used in place of the supplied antenna.
 ap3750 — Contains one 802.11b/g radio and one 802.11a radio
with connectors for optional external antennas for each radio.
 ap7250 — Contains one 802.11b/g radio. An external antenna
may be used in place of the supplied antenna.
 ap8250 — Contains one 802.11b/g radio. It also has the ability to
have an additional 802.11a radio installed in it. An external
dual-mode antenna may be used in place of the supplied antenna.
 ap8750 — Contains one 802.11a radio and one 802.11b/g radio.
An external dual-mode antenna may be used in place of the
supplied antenna for the 802.11b/g radio.
 mp-52 — Contains one 802.11a radio and one 802.11b radio,
with adjustable external antennas.
 mp-101 — Contains one radio that can be configured through
software for 802.11a or 802.11b.
 mp-122 — Contains one 802.11a radio and one 802.11b/g radio.
 mp-241 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g.
 mp-252 — Contains one 802.11a radio and one 802.11b radio.