Command Reference Guide

68 CHAPTER 4: PORT COMMANDS
Table 11 describes the fields in the display port-group output.
See Also
 clear port-group on page 63
 set port-group on page 81
display port poe Displays status information for ports on which Power over Ethernet (PoE)
is enabled.
Syntax —
display port poe [port-list]
 port-list — List of physical ports. If you do not specify a port list,
PoE information is displayed for all ports.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Examples — The following command displays PoE information for all
ports on a WX1200 switch:
WX1200# display port poe
Link Port PoE PoE
Port Name Status Type config Draw
============================================================
1 1 up - disabled off
2 2 down - disabled off
3 3 down - disabled off
4 4 down MAP enabled 1.44
5 5 down - disabled off
6 6 down - disabled off
Table 12 describes the fields in this display.
Table 11 Output for display port-group
Field Description
Port group Name and state (enabled or disabled) of the port
group.
Ports Ports contained in the port group.