Command Reference Guide

clear port type 65
Examples — The following command clears the preference set on port 2
on a WX4400 switch:
WX4400# clear port preference 2
See Also
 display port preference on page 69
 set port preference on page 85
clear port type Removes all configuration settings from a port and resets the port as a
network port.
CAUTION: When you clear a port, MSS ends user sessions that are using
the port.
Syntax —
clear port type port-list
 port-list — List of physical ports. MSS resets and removes the
configuration from all the specified ports.
Defaults — The cleared port becomes a network port but is not placed
in any VLANs.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Use this command to change a port back to a network port. All
configuration settings specific to the port type are removed. For example,
if you clear an MAP access point port, all MAP-specific settings are
removed. Table 10 lists the default network port settings that MSS
applies when you clear a port’s type.
Table 10 Network port defaults
Port Parameter Setting
VLAN membership None.
Note: Although the command changes a port to a
network port, the command does not place the port
in any VLAN. To use the port in a VLAN, you must
add the port to the VLAN.