Command Reference Guide

592 CHAPTER 22: BOOT PROMPT COMMANDS
autoboot Displays or changes the state of the autoboot option. The autoboot
option controls whether a WX switch automatically boots a system image
after initializing the hardware, following a system reset or power cycle.
Syntax —
autoboot [ON | on | OFF | off]
 ON — Enables the autoboot option.
 on — Same effect as ON.
 OFF — Disables the autoboot option.
 off — Same effect as OFF.
Defaults — The autoboot option is enabled by default.
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
Examples — The following command displays the current setting of the
autoboot option:
boot> autoboot
The autoboot flag is on.
See Also
 boot on page 593
Boot Profile
Management, cont.
next on page 603
change on page 595
delete on page 597
Diagnostics diag on page 598
test on page 605
Table 110 Boot Prompt Commands by Usage (continued)
Type Command