Command Reference Guide

22
BOOT PROMPT COMMANDS
Boot prompt commands enable you to perform basic tasks, including
booting a system image file, from the boot prompt (boot>). A CLI session
enters the boot prompt if MSS does not boot successfully or you
intentionally interrupt the boot process. To interrupt the boot process,
press q followed by Enter (return).
CAUTION: Generally, boot prompt commands are used only for
troubleshooting. 3Com recommends that you use these commands only
when working with 3Com Technical Support to diagnose a system issue.
In particular, commands that change boot parameters can interfere with
a WX switch’s ability to boot successfully.
Boot Prompt
Commands by
Usage
This chapter presents boot prompt commands alphabetically. Use
Table 110 to locate commands in this chapter based on their use.
Table 110 Boot Prompt Commands by Usage
Type Command
Command Information ls on page 602
help on page 602
Booting boot on page 593
reset on page 604
autoboot on page 592
File Management dir on page 598
fver on page 601
version on page 606
Boot Profile Management display on page 599
create on page 596