Command Reference Guide

58 CHAPTER 3: SYSTEM SERVICE COMMANDS
set system location Stores location information for the WX switch.
Syntax —
set system location string
 string — Alphanumeric string up to 256 characters long, with no
blank spaces.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You cannot include spaces in the system location string.
To view the system location string, type the display system command.
Examples — To store the location of the WX switch in the WX’s
configuration, type the following command:
WX4400# set system location first-floor-bldg3
success: change accepted.
See Also
 clear system on page 39
 display system on page 42
 set system contact on page 54
 set system name on page 58
set system name Changes the name of the WX switch from the default system name and
also provides content for the CLI prompt, if you do not specify a prompt.
Syntax —
set system name string
 string — Alphanumeric string up to 256 characters long, with no
blank spaces. Use a unique name for each WX switch.