Command Reference Guide

578 CHAPTER : SNOOP COMMANDS
Usage — To display the mappings for all snoop filters, use the display
snoop command.
Examples — The following command shows the mapping for snoop
filter snoop1:
WX1200# display snoop map snoop1
filter 'snoop1' mapping
Dap: 3 Radio: 2
See Also
 clear snoop map on page 570
 set snoop map on page 574
 display snoop on page 576
display snoop stats Displays statistics for enabled snoop filters.
Examples — display snoop stats [filter-name [dap-num [radio
{1 | 2}]]]
 filter-name — Name of the snoop filter.
 dap-num — Number of a Distributed MAP to which the snoop filter is
mapped.
 radio 1 — Radio 1 of the MAP.
 radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — The MAP retains statistics for a snoop filter until the filter is
changed or disabled. The MAP then clears the statistics.