Command Reference Guide

set snoop 571
The following command removes all snoop filter mappings from all
radios:
WX1200# clear snoop map all
success: change accepted.
See Also
 set snoop map on page 574
 display snoop on page 576
 display snoop map on page 577
set snoop Configures a snoop filter.
set snoop filter-name [condition-list] [observer ip-addr]
[snap-length num]
 filter-name — Name for the filter. The name can be up to 32
alphanumeric characters, with no spaces.
 condition-list — Match criteria for packets. Conditions in the list
are ANDed. Therefore, to be copied and sent to an observer, a packet
must match all criteria in the condition-list. You can specify up to
eight of the following conditions in a filter, in any order or
combination:
 frame-type {eq | neq} {beacon | control | data |
management | probe}
 channel {eq | neq} channel
 bssid {eq | neq} bssid
 src-mac {eq | neq} mac-addr
 dest-mac {eq | neq} mac-addr
 host-mac {eq | neq} mac-addr
 mac-pair mac-addr1 mac-addr2
To match on packets to or from a specific MAC address, use the
dest-mac or src-mac option. To match on both send and receive
traffic for a host address, use the host-mac option. To match on a
traffic flow (source and destination MAC addresses), use the mac-pair
option. This option matches for either direction of a flow, and either
MAC address can be the source or destination address.