Command Reference Guide

20
SNOOP COMMANDS
Use snoop commands to monitor wireless traffic, by using a Distributed
MAP as a sniffing device. The MAP copies the sniffed 802.11 packets and
sends the copies to an observer, which is typically a protocol analyzer
such as Ethereal or Tethereal.
(For more information, including setup instructions for the monitoring
station, see the “Remotely Monitoring Traffic” section in the
“Troubleshooting an WX Switch” chapter of the Wireless LAN Switch
Configuration Guide.)
This chapter presents snoop commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 107 Snoop Commands by Usage
Remote monitoring
(snooping)
set snoop on page 571
display snoop info on page 577
clear snoop on page 570
set snoop map on page 574
display snoop map on page 577
display snoop on page 576
clear snoop map on page 570
set snoop mode on page 575
display snoop stats on page 578