Command Reference Guide

set trace authorization 565
Examples — The following command starts a trace for information
about user jose’s authentication:
WX4400# set trace authentication user jose
success: change accepted.
See Also
 clear trace on page 562
 display trace on page 563
set trace
authorization
Traces authorization information.
Syntax —
set trace authorization [mac-addr mac-address]
[port port-num] [user username] [level level]
 mac-addr mac-address — Traces a MAC address. Specify a MAC
address, using colons to separate the octets (for example,
00:11:22:aa:bb:cc).
 port port-num — Traces on a WX a port number.
 user username — Traces a user. Specify a username of up to
80 alphanumeric characters with no spaces.
 level level — Determines the quantity of information included in the
output. You can set the level with an integer from 1 to 10, where level 10
provides the most information. Levels 1 through 5 provide user-readable
information. If you do not specify a level, level 5 is the default.
Defaults — The default trace level is 5.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command starts a trace for information for
authorization for MAC address 00:01:02:03:04:05:
WX4400# set trace authorization mac-addr 00:01:02:03:04:05
success: change accepted.
See Also
 clear trace on page 562
 display trace on page 563