Command Reference Guide

display boot 547
display boot Displays the system image and configuration filenames used after the last
reboot and configured for use after the next reboot.
Syntax —
display boot
Defaults — None.
Access — Access.
History —Introduced in MSS Version 3.0.
Examples — The following command shows the boot information for a
WX switch:
WX1200# display boot
Configured boot image: boot0:WXB03002.Rel
Configured boot configuration: file:newconfig
Booted version: 3.0.1
Booted image: boot1:WXB03001.Rel
Booted configuration: file:configuration
Product model: WX1200
Table 104 describes the fields in the display boot output.
See Also
 display version on page 549
 reset system on page 554
 set boot configuration-file on page 558
Table 104 Output for display boot
Field Description
Configured boot
image
Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configured boot
configuration
Configuration filename MSS will use to boot next time the
software is rebooted.
Booted version Software version the switch is running.
Booted image Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
Booted configuration Configuration filename MSS used to load the configuration
the last time the software was rebooted.