Command Reference Guide

set rfdetect log 531

Examples — The following command configures MSS to ignore BSSID

aa:bb:cc:11:22:33 during RF scans:

WX1200# set rfdetect ignore aa:bb:cc:11:22:33

success: MAC aa:bb:cc:11:22:33 is now ignored.

See Also

 clear rfdetect ignore on page 513

 display rfdetect ignore on page 520

set rfdetect log Disables or reenables generation of log messages when rogues are

detected or when they disappear.

Syntax —

set rfdetect log {enable | disable}

 enable — Enables logging of rogues.

 disable — Disables logging of rogues.

Defaults — RF detection logging is enabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

The log messages for rogues are generated only on the seed and appear

only in the seed’s log message buffer. Use the display log buffer

command to display the messages in the seed switch’s log message

buffer.

Examples — The following command enables RF detection logging for

the Mobility Domain managed by this seed switch:

WX1200# set rfdetect log enable

success: rfdetect logging is enabled.