Command Reference Guide

518 CHAPTER 17: RF DETECTION COMMANDS
See Also
 clear rfdetect attack-list on page 512
 set rf detect countermeasures on page 530
 set rfdetect countermeasures mac on page 530
display rfdetect
data
Displays information about the APs detected by a WX switch.
Syntax — display rfdetect data
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.Vendor, Type and Flags fields
added to MSS Version 4.0
Usage — You can enter this command on any WX switch in the Mobility
Domain. The output applies only to the switch on which you enter the
command. To display all devices that a specific 3Com radio has detected,
even if the radio is managed by another WX switch, use the display
rfdetect visible command.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.
Only one MAC address is listed for each 3Com radio, even if the radio is
beaconing multiple SSIDs.
Countermeasures
Radio MAC
MAC address of the 3Com radio sending countermeasures
against the rogue.
If the field value is Not Started, MSS has not started
countermeasures against the rogue yet.
WX-IPaddr System IP address of the WX switch that is managing the
MAP that is sending or will send countermeasures.
Port/Radio/Channel Port number, radio number, and channel number of the
countermeasures radio. For a Distributed MAP, the
connection number is labeled dap. (This stands for
distributed ap.)
Table 95 display rfdetect countermeasures Output (continued)
Field Description