Command Reference Guide

17
RF DETECTION COMMANDS
MSS automatically performs RF detection scans on enabled and disabled
radios to detect rogue access points. A rogue access point is a BSSID
(MAC address associated with an SSID) that does not belong to a 3Com
switch and is not a member of the ignore list configured on the seed
switch of the Mobility Domain.
MSS can issue countermeasures against rogue devices to prevent clients
from being able to use them.
You can configure RF detection parameters on individual WX switches.
Commands by
Usage
This chapter presents RF detection commands alphabetically. Use
Table 94 to locate the commands in this chapter based on their use.
Table 94 RF Detection Commands by Usage
Type Command
Rogue Information display rfdetect clients on page 535
display rfdetect mobility-domain on page 521
display rfdetect data on page 518
display rfdetect visible on page 526
display rfdetect counters on page 515
Countermeasures display rfdetect countermeasures on page 517
Permitted
Vendor List
set rfdetect vendor-list on page 533
display rfdetect vendor-list on page 525
clear rfdetect vendor-list on page 515