Command Reference Guide

15
802.1X MANAGEMENT
COMMANDS
Use 802. IEEE X management commands to modify the default settings
for IEEE 802.1X sessions on an WX switch. For best results, change the
settings only if you are aware of a problem with the WX switch’s 802.1X
performance.
CAUTION: 802.1X parameter settings are global for all SSIDs configured
on the switch.
Commands by
Usage
This chapter presents 802.1X commands alphabetically. Use Table 86 to
locate commands in this chapter based on their use. For information
about configuring 802.1X commands for user authentication, see “AAA
Commands” on page 199.
Table 86 802.1X Commands by Usage
Type Command
Wired Authentication Port
Control
set dot1x port-control on page 490
clear dot1x port-control on page 479
set dot1x authcontrol on page 486
Keys set dot1x key-tx on page 488
set dot1x tx-period on page 494
clear dot1x tx-period on page 483
set dot1x wep-rekey on page 495
set dot1x wep-rekey-period on page 496
Bonded Authentication clear dot1x bonded-period on page 478
set dot1x bonded-period on page 487
Reauthentication set dot1x reauth on page 491
set dot1x reauth-max on page 492