Command Reference Guide

474 CHAPTER 14: RADIUS AND SERVER GROUP COMMANDS
See Also
 display aaa on page 217
 set authentication admin on page 226
 set authentication console on page 228
 set authentication dot1x on page 230
 set authentication last-resort on page 234
 set authentication mac on page 236
 set authentication web on page 239
 set radius on page 468
 set server group on page 474
set server group Configures a group of one to four RADIUS servers.
Syntax —
set server group group-name members server-name1
[server-name2] [server-name3] [server-name4]
 group-name — Server group name of up to 32 characters, with no
spaces or tabs.
 members server-name1, server-name2, server-name3,
server-name4
— The names of one or more configured RADIUS
servers. You can enter up to four server names.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must assign all group members simultaneously, as shown
in the example. To enable load balancing, use set server group
load-balance enable.
Do not use the same name for a RADIUS server and a RADIUS server
group.
Examples — To set server group shorebirds with members heron, egret,
and sandpiper, type the following command:
WX1200# set server group shorebirds members heron egret