Command Reference Guide

470 CHAPTER 14: RADIUS AND SERVER GROUP COMMANDS
Usage — The WX system IP address must be set before you use this
command.
Examples — The following command sets the WX system IP address as
the address of the RADIUS client:
WX4400# set radius client system-ip
success: change accepted.
See Also
 clear radius client system-ip on page 465
 set system ip-address on page 57
set radius proxy
client
Adds a RADIUS proxy entry for a third-party AP. The proxy entry specifies
the IP address of the AP and the UDP port on which the WX switch listens
for RADIUS traffic from the AP.
Syntax — set radius proxy client address ip-address
[port udp-port-number] key string
 address ip-address — IP address of the third-party AP. Enter the
address in dotted decimal notation.
 port udp-port-number — UDP port on which the WX switch listens
for RADIUS traffic from the AP.
 key string — Password (shared secret key) the WX switch uses to
authenticate and encrypt RADIUS communication.
Defaults — The default UDP port number is 1812.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — AAA for third-party AP users has additional configuration
requirements. See the “Configuring AAA for Users of Third-Party APs”
section in the “Configuring AAA for Network Users” chapter of the
Wireless LAN Switch and Controller Configuration Guide.
Examples — The following command configures a RADIUS proxy entry
for a third-party AP RADIUS client at 10.20.20.9, sending RADIUS traffic
to the default UDP port 1812 on the WX: