Command Reference Guide

RADIUS AND SERVER GROUP

COMMANDS

Use RADIUS commands to set up communication between an WX switch

and groups of up to four RADIUS servers for remote authentication,

authorization, and accounting (AAA) of administrators and network

users.

Commands by

Usage

This chapter presents RADIUS commands alphabetically. Use Table 85 to

locate commands in this chapter based on their uses.

(For information about RADIUS attributes, see the RADIUS appendix in

the Wireless LAN Switch and Controller Configuration Guide.)

Table 85 RADIUS Commands by Usage

Type Command

RADIUS Client set radius client system-ip on page 469

clear radius client system-ip on page 465

RADIUS Servers set radius on page 468

set radius server on page 472

clear radius on page 464

clear radius server on page 467

Server Groups set server group on page 474

set server group load-balance on

page 475

clear server group on page 467

RADIUS Proxy set radius proxy client on page 470

set radius proxy port on page 471

clear radius proxy client on page 466

clear radius proxy port on page 466