Command Reference Guide

10
STP COMMANDS
Use Spanning Tree Protocol (STP) commands to configure and manage
spanning trees on the virtual LANs (VLANs) configured on a wireless LAN
switch or controller, to maintain a loop-free network.
STP Commands by
Usage
This chapter presents STP commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 68 STP Commands by Usage
Type Command
STP State set spantree on page 388
display spantree on page 376
display spantree blockedports on page 379
Bridge Priority set spantree priority on page 397
Port Cost set spantree portcost on page 392
set spantree portvlancost on page 395
display spantree portvlancost on page 381
clear spantree portcost on page 372
clear spantree portvlancost on page 373
Port Priority set spantree portpri on page 394
set spantree portvlanpri on page 396
clear spantree portpri on page 373
clear spantree portvlanpri on page 374
Timers set spantree fwddelay on page 390
set spantree hello on page 390
set spantree maxage on page 391
Fast Convergence set spantree portfast on page 393
display spantree portfast on page 380