Command Reference Guide

set service-profile beacon 355
The WebAAA fallthru authentication type is not supported in conjunction
with WPA encryption using preshared keys (PSK) for the same SSID. These
options are configurable together but are not compatible. WebAAA
traffic is not encrypted, whereas the PSK four-way handshake requires a
client to already be authenticated and for encryption to be in place.
Examples — The following command enables PSK authentication for
service profile wpa_clients:
WX4400# set service-profile wpa_clients auth-psk enable
success: change accepted.
See Also
 display service-profile on page 302
 set service-profile auth-dot1x on page 351
 set service-profile psk-raw on page 361
 set service-profile wpa-ie on page 370
set service-profile
beacon
Disables or reenables beaconing of the SSID managed by the service
profile.
A MAP radio responds to an 802.11 probe any request with only the
beaconed SSID(s). For a nonbeaconed SSID, radios respond only to
directed 802.11 probe requests that match the nonbeaconed SSID’s SSID
string.
When you disable beaconing for an SSID, the radio still sends beacon
frames, but the SSID name in the frames is blank.
Syntax —
set service-profile name beaconed {enable | disable}
 name — Service profile name.
 enable — Enables beaconing of the SSID managed by the service
profile.
 disable — Disables beaconing of the SSID managed by the service
profile.
Defaults — Beaconing is enabled by default.
Access — Enabled.