Command Reference Guide

set service-profile auth-dot1x 351
Defaults — WMM is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — When WMM is disabled, MAP forwarding prioritization is
optimized for SpectraLink Voice Priority (SVP) instead of WMM, and the
MAP does not tag packets it sends to the WX. Otherwise, classification
and tagging remain in effect. (For information, see the “Wi-Fi
Multimedia” chapter of the Wireless LAN Switch and Controller
Configuration Guide.)
If you plan to use SVP or another non-WMM type of prioritization, you
must configure ACLs to tag the packets. (See the “Enabling Prioritization
for Legacy Voice over IP” section in the “Configuring and Managing
Security ACLs” chapter of the Wireless LAN Switch and Controller
Configuration Guide..)
Examples — The following command disables WMM in radio profile
radprofsvp:
WX1200# set radio-profile radprofsvp wmm disable
success: change accepted.
See Also
 set radio-profile mode on page 342
 display radio-profile on page 298
set service-profile
auth-dot1x
Disables or reenables 802.1X authentication of Wi-Fi Protected Access
(WPA) clients by MAP radios, when the WPA information element (IE) is
enabled in the service profile that is mapped to the radio profile that the
radios are using.
Syntax —
set service-profile
name auth-dot1x {enable | disable}
 name — Service profile name.
 enable — Enables 802.1X authentication of WPA clients.
 disable — Disables 802.1X authentication of WPA clients.