Command Reference Guide

342 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
See Also
 display radio-profile on page 298
 set radio-profile mode on page 342
 set radio-profile max-rx-lifetime on page 340
set radio-profile
mode
Creates a new radio profile, or disables or reenables all MAP radios that
are using a specific profile.
Syntax —
set radio-profile name [mode {enable | disable}]
 radio-profile name — Radio profile name of up to 16 alphanumeric
characters, with no spaces.
Use this command without the mode enable or mode disable
option to create a new profile.
 mode enable — Enables the radios that use this profile.
 mode disable — Disables the radios that use this profile.
Defaults — Each radio profile that you create has a set of properties with
factory default values that you can change with the other set
radio-profile commands in this chapter. Table 66 lists the parameters
controlled by a radio profile and their default values.
Table 66 Defaults for Radio Profile Parameters
Parameter Default Value
Radio Behavior When Parameter Set to
Default Value
11g-only disable Allows associations with 802.11g and
802.11b clients.
Note: This parameter applies only to
802.11b/g radios.
active-scan enable Sends probe any requests (probe requests
with a null SSID name) to solicit probe
responses from other access points.
auto-tune enable Allows dynamic configuration of channel
and power settings by MSS.
beacon-interval 100 Waits 100 ms between beacons.
countermeasures Not configured Does not issue countermeasures against
any device.