Command Reference Guide

340 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
 threshold — Number of times the radio can send the same long
unicast frame. You can enter a value from 1 through 15.
Defaults — The default long unicast retry threshold for MAP radios is 5
attempts.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
Examples — The following command changes the long retry threshold
for radio profile rp1 to 8:
WX4400# set radio-profile rp1 long-retry 8
success: change accepted.
See Also
 display radio-profile on page 298
 set radio-profile mode on page 342
 set radio-profile short-retry on page 350
set radio-profile
max-rx-lifetime
Changes the maximum receive threshold for the MAP radios in a radio
profile. The maximum receive threshold specifies the number of
milliseconds that a frame received by a radio can remain in buffer
memory.
Syntax —
set radio-profile name max-rx-lifetime time
 name — Radio profile name.
 time — Number of milliseconds. You can enter a value from 500
(0.5 second) through 250,000 (250 seconds).
Defaults — The default maximum receive threshold for MAP radios is
2000 ms (2 seconds).
Access — Enabled.
History —Introduced in MSS Version 3.0.