Command Reference Guide

set radio-profile frag-threshold 339
set radio-profile
frag-threshold
Changes the fragmentation threshold for the MAP radios in a radio
profile. The fragmentation threshold specifies the maximum length a
frame is allowed to be without being broken into multiple frames before
transmission.
Syntax —
set radio-profile name frag-threshold threshold
 name — Radio profile name.
 threshold — Maximum frame length, in bytes. You can enter a value
from 256 through 2346.
Defaults — The default fragmentation threshold for MAP radios is 2346
bytes.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
Examples — The following command changes the fragmentation
threshold for radio profile rp1 to 1500 bytes:
WX4400# set radio-profile rp1 frag-threshold 1500
success: change accepted.
See Also
 display radio-profile on page 298
 set radio-profile mode on page 342
set radio-profile
long-retry
Changes the long retry threshold for the MAP radios in a radio profile.
The long retry threshold specifies the number of times a radio can send a
long unicast frame without receiving an acknowledgment. A long unicast
frame is a frame that is equal to or longer than the Request-to-Send (RTS)
threshold.
Syntax —
set radio-profile name long-retry threshold
 name — Radio profile name.