Command Reference Guide

set radio-profile countermeasures 337
set
radio-profile
countermeasures
CAUTION: Countermeasures affect wireless service on a radio. When a
MAP radio is sending countermeasures, the radio is disabled for use by
network traffic, until the radio finishes sending the countermeasures.
Enables or disables countermeasures for on the MAP radios managed by
a radio profile. Countermeasures are packets sent by a radio to prevent
clients from being able to use rogue access points.
MAP radios can also issue countermeasures against interfering devices.
An interfering device is not part of the network but also is not a rogue.
No client connected to the device has been detected communicating with
any network entity listed in the forwarding database (FDD) of any WX
switch in the Mobility Domain. Although the interfering device is not
connected to your network, the device might be causing RF interference
with MAP radios.
Syntax —
set radio-profile name countermeasures { all | rogue }
 name — Radio profile name.
 all — Configures radios to attack rogues and interfering devices.
 rogue — Configures radios to attack rogues only.
Defaults — Countermeasures are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Examples — The following command enables countermeasures in radio
profile radprof3 for rogues only:
WX-1200# set radio-profile radprof3 countermeasures rogue
success: change accepted.
The following command disables countermeasures in radio profile
radprof3:
WX-1200# clear radio-profile radprof3 countermeasures
success: change accepted.