Command Reference Guide

330 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
set radio-profile
active-scan
Disables or reenables active RF detection scanning on the MAP radios
managed by a radio profile. When active scanning is enabled, MAP radios
look for rogue devices by sending probe any requests (probe requests
with a null SSID name), to solicit probe responses from other access
points.
Passive scanning is always enabled and cannot be disabled. During
passive scanning, radios look for rogues by listening for beacons and
probe responses.
Syntax —
set radio-profile name active-scan {enable |
disable}
 name — Radio profile name.
 enable — Configures radios to actively scan for rogues.
 disable — Configures radios to scan only passively for rogues by
listening for beacons and probe responses.
Defaults — Active scanning is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — You can enter this command on any WX switch in the Mobility
Domain. The command takes effect only on that switch.
Examples — The following command disables active scan in radio profile
radprof3:
WX-1200# set radio-profile radprof3 active-scan disable
success: change accepted.
set radio-profile
auto-tune
channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the
MAP radios in a radio profile.
Syntax —
set radio-profile name auto-tune channel-config
{enable | disable}
 name — Radio profile name.