Command Reference Guide

set radio-profile 11g-only 329

set radio-profile

11g-only

Configures each 802.11b/g radio in a radio profile to allow associations

with 802.11g clients only.

Syntax —

set radio-profile name 11g-only {enable | disable}

 name — Radio profile name.

 enable — Configures radios to allow associations with 802.11g

clients only.

 disable — Configures radios to allow associations with 802.11g

clients and 802.11b clients.

Defaults — The default setting is disable. 3Com 802.11b/g radios allow

associations with 802.11g and 802.11b clients by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You must disable all radios that are using a radio profile before

you can change parameters in the profile. Use the set radio-profile

mode command

Even when association of 802.11b clients is disabled, if an 802.11b/g

radio detects a beacon from an 802.11b network, the radio enters

protection mode to guard against interference.

The set radio-profile 11g-only command does not affect the radio

support configured with the set port type ap command. For example, if

you configure a radio to be 802.11b only when you set the port type, the

set radio-profile 11g-only enable command does not enable 802.11g

support on the radio.

Examples — The following command configures the 802.11b/g radios in

radio profile rp1 to allow associations from 802.11g clients only:

WX4400# set radio-profile rp1 11g-only enable

success: change accepted.