Command Reference Guide

328 CHAPTER 9: MANAGED ACCESS POINT COMMANDS

set {ap | dap}

upgrade-firmware

Disables or reenables automatic upgrade of an MAP access point’s boot

firmware.

Syntax —

set {ap port-list | dap {dap-num | auto}}

upgrade-firmware {enable | disable}

 ap port-list — List of ports connected to the MAP access point(s) on

which to allow automatic firmware upgrades.

 dap dap-num — Number of a Distributed MAP on which to allow

automatic firmware upgrades.

 dap auto — Configures firmware upgrades for the MAP

configuration template. (See set dap auto on page 306.)

 enable — Enables automatic firmware upgrades.

 disable — Disables automatic firmware upgrades.

Defaults — Automatic firmware upgrades of MAP access points are

enabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0. Option

auto to configure the

MAP configuration template added in MSS Version 4.0.

Usage — When the feature is enabled on an WX port, an MAP access

point connected to that port upgrades its boot firmware to the latest

version stored on the WX switch while booting.

Examples — The following command disables automatic firmware

upgrades on the MAP access point connected to port 6:

WX1200# set ap 6 upgrade-firmware disable