Command Reference Guide

326 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You also can configure a radio’s channel on the same
command line. Use the channel option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the transmit power on
the 802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
 “display {ap | dap} config” on page 277
 set {ap | dap} radio channel on page 320
set dap security Sets security requirements for management sessions between an WX
switch and its Distributed MAPs.
This feature applies to Distributed MAPs only, not to directly connected
MAPs configured on MAP access ports. In addition, MAP models AP7250,
AP8250, AP8750, MAP-101 and MAP-122 do not have encryption keys
and do not support this feature regardless of how they are connected to
the WX switch.
The maximum transmission unit (MTU) for encrypted MAP management
traffic is 1498 bytes, whereas the MTU for unencrypted management
traffic is 1474 bytes. Make sure the devices in the intermediate network
between the WX switch and Distributed MAP can support the higher
MTU.
Syntax — set dap security {require | none | optional}