Command Reference Guide

320 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
A radio also can increase power, in 1 dBm increments, if a client falls
below the minimum allowed data rate. After a radio increases power, all
clients must be at the minimum data rate or higher and the maximum
retransmissions must be within the allowed percentile, before the radio
begins reducing power again.
Examples — The following command changes the max-retransmissions
value to 20:
WX1200# set ap 6 radio 1 auto-tune max-retransmissions 20
success: change accepted.
See Also
 set {ap | dap} radio auto-tune max-power on page 317
 set radio-profile auto-tune power-backoff- timer on page 333
 set radio-profile auto-tune power-config on page 334
 set radio-profile auto-tune power-interval on page 335
set {ap | dap} radio
channel
Sets an MAP radio’s channel.
Syntax — set {ap port-list | dap dap-num} radio {1 | 2}
channel channel-number
 ap port-list — List of ports connected to the MAP access points on
which to set the channel.
 dap dap-num — Number of a Distributed MAP on which to set the
channel.
 radio 1 — Radio 1 of the MAP.
 radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
 channel channel-number — Channel number. The valid channel
numbers depend on the country of operation.
Defaults — The default channel depends on the radio type:
 The default channel number for 802.11b/g is 6.
 The default channel number for 802.11a is the lowest valid channel
number for the country of operation.
Access — Enabled.