Command Reference Guide

318 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Access — Enabled.
History —Introduced in MSS Version 3.0. MSS Version 4.0 added
auto
option for configuration of the MAP configuration template.
Examples — The following command sets the maximum power that
RF Auto-Tuning can set on radio 1 on the MAP access point on port 6 to
12 dBm.
WX1200# set ap 6 radio 1 auto-tune max-power 12
success: change accepted.
See Also
 set {ap | dap} radio auto-tune max- retransmissions on page 318
 set radio-profile auto-tune power-backoff- timer on page 333
 set radio-profile auto-tune power-config on page 334
 set radio-profile auto-tune power-interval on page 335
set {ap | dap} radio
auto-tune max-
retransmissions
Sets the maximum percentage of client retransmissions a radio can
experience before RF Auto-Tuning considers changing the channel on the
radio. A high percentage of retransmissions is a symptom of interference
on the channel.
Syntax —
set {ap port-list | dap (dap-num | auto)}
radio {1 | 2} auto-tune max-retransmissions retransmissions
 ap port-list — List of ports connected to the MAP access points on
which to set the maximum retransmissions.
 dap dap-num — Number of a Distributed MAP on which to set the
maximum retransmissions.
 dap auto — Sets the maximum retransmissions for radios configured
by the MAP configuration template. (See set dap auto on page 306.)
 radio 1 — Radio 1 of the MAP.
 radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
 retransmissions — Percentage of packets that can result in
retransmissions without resulting in a channel change. You can
specify from 1 to 100.