Command Reference Guide

set {ap | dap} radio auto-tune max-power 317
Usage — This command applies only to MAP models that support
external antennas. External 802.11b/g antennas are supported on
MAP-372, MAP-341, MAP-352, and MAP-262. External 802.11a
antennas are supported only on model MAP-372. External dual-mode
antennas are supported on AP2750, AP3750, AP7250, AP8250 and
AP8750.
Examples — The following command configures the 802.11b/g radio on
Distributed MAP 1 to use antenna model ANT1060:
WX4400# set dap 1 radio 1 antennatype ANT1060
success: change accepted.
See Also
 display {ap | dap} config on page 277
set {ap | dap} radio
auto-tune
max-power
Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax — set {ap port-list | dap (dap-num | auto)}
radio {1 | 2} auto-tune max-power power-level
 ap port-list — List of ports connected to the MAP access points on
which to set the maximum power.
 dap dap-num — Number of a Distributed MAP on which to set the
maximum power.
 dap auto — Sets the maximum power for radios configured by the
MAP configuration template. (See set dap auto on page 306.)
 radio 1 — Radio 1 of the MAP.
 radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
 power-level — Maximum power setting RF Auto-Tuning can assign
to the radio, expressed as the number of decibels in relation to 1
milliwatt (dBm). You can specify a value from 1 up to the maximum
value allowed for the country of operation.
The power-level can be a value from 1 to 20.
Defaults — The default maximum power setting that RF Auto-Tuning
can set on a radio is the highest setting allowed for the country of
operation or highest setting supported on the hardware, whichever is
lower.