Command Reference Guide

set {ap | dap} name 315
set {ap | dap} name Changes an MAP name.
Syntax —
set {ap port-list | dap dap-num} name name
 ap port-list — List of ports connected to the MAP access point to
rename.
 dap dap-num — Number of a Distributed MAP to rename.
 name — Alphanumeric string of up to 16 characters, with no spaces.
Defaults — The default name of a directly attached MAP is based on the
port number of the MAP access port attached to the MAP. For example,
the default name for a MAP on MAP access port 1 is MAP01. The default
name of a Distributed MAP is based on the number you assign to it when
you configure the connection. For example, the default name for
Distributed MAP 1 is DMP01.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the name of the MAP
access point on port 1 to techpubs:
WX1200# set ap 1 name techpubs
success: change accepted.
See Also
 “display {ap | dap} config” on page 277
set {ap | dap} radio
antennatype
Sets the model number for an external antenna.
Syntax — set {ap port-list | dap dap-num} radio
{1 antennatype ANT1060 | ANT1120 | ANT1180 | internal}
{2 antennatype ANT5060 | ANT5120 | ANT5180 | internal}
{ {1|2} antennatype ANT3C591 | ANT3C592 | ANT3C597 | ANT3C598
| internal}
 ap port-list — List of ports connected to the MAP access points on
which to set the channel.
 dap dap-num — Number of a Distributed MAP on which to set the
channel.