Command Reference Guide

314 CHAPTER 9: MANAGED ACCESS POINT COMMANDS

 dap dap-num — Number of a Distributed MAP to add to the group.

 dap auto —Configures blink mode for the MAP configuration

template. (See set dap auto on page 306.)

 name — MAP access point group name of up to 16 alphanumeric

characters, with no spaces.

Defaults — MAP access points are not grouped by default.

Access — Enabled.

History —Introduced in MSS Version 3.0. MSS Version 4.0 added

auto

option for configuration of the MAP configuration template.

Usage — You can assign any subset or all of the MAP access points

connected to an WX switch to a group on that switch. All access points in

a group must be connected to the same WX switch.

If you use the name none, spelled in any combination of capital or

lowercase letters, the specified MAP access point is cleared from all MAP

access point groups.

Examples — The following command configures an MAP access point

group named loadbalance1 that contains the MAP access points on ports

1, 3, and 5:

WX1200# set ap 1,3,5 group loadbalance1

success: change accepted.

The following command removes the MAP access point on port 4 from all

MAP access point groups:

WX1200# set ap 4 group none

success: change accepted.