Command Reference Guide

set {ap | dap} group 313
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — MAPs are configured with an encryption key pair at the
factory. The fingerprint for the public key is displayed on a label on the
back of the MAP, in the following format:
RSA
aaaa:aaaa:aaaa:aaaa:
aaaa:aaaa:aaaa:aaaa
If a MAP is already installed and operating, you can use the display dap
status command to display the fingerprint. The display dap config
command lists a MAP’s fingerprint only if the fingerprint has been verified
in MSS. If the fingerprint has not been verified, the fingerprint
information in the command output is blank.
Examples — The following example verifies the fingerprint for
Distributed MAP 8:
WX-1200# set dap 8 fingerprint
b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
See Also
 set dap security on page 326
 display {ap | dap} config on page 277
 display {ap | dap} status on page 287
set {ap | dap} group Configures a named group of MAP access points. MSS automatically load
balances sessions among the access points in a group. To balance the
sessions, MSS rejects an association request for an access point’s radio if
that radio has at least four more active sessions than the radio of the
same type with the least number of active sessions within the group.
Syntax —
set {ap port-list | dap (dap-num | auto)} group name
 ap port-list — List of MAP access ports to add to the group.