Command Reference Guide

312 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Syntax — set {ap port-list | dap (dap-num | auto)}
blink {enable | disable}
 ap port-list — List of ports connected to the MAP access points on
which to turn blink mode on or off.
 dap dap-num — Number of a Distributed MAP on which to turn blink
mode on or off.
 dap auto —Configures blink mode for the MAP configuration
template. (See set dap auto on page 306.)
 enable — Enables blink mode.
 disable — Disables blink mode.
Defaults — LED blink mode is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option
auto added for
configuration of the MAP configuration template in MSS Version 4.0.
Usage — Changing the LED blink mode does not alter operation of the
MAP access point. Only the behavior of the LEDs is affected.
Examples — The following command enables LED blink mode on the
MAP access points connected to ports 3 and 4:
WX1200# set ap 3-4 blink enable
success: change accepted.
set dap fingerprint Verifies a MAP’s fingerprint on an WX switch. If MAP-WX security is
required by a WX switch, a MAP can establish a management session
with the switch only if you have verified the MAP’s identity by verifying its
fingerprint on the switch.
Syntax —
set dap num fingerprint hex
dap
dap-num — Number of the Distributed MAP whose fingerprint you
are verifying.
hex — The 16-digit hexadecimal number of the fingerprint. Use a colon
between each digit. Make sure the fingerprint you enter matches the
fingerprint used by the MAP.