Command Reference Guide

set {ap | dap} blink 311
MAP selection of an WX switch is sticky. After a MAP selects an WX
switch to boot from, the MAP continues to use that switch for its active
data link even if another switch configured with high bias for the MAP
becomes available.
Examples — The following command changes the bias for a Distributed
MAP to low:
WX4400# set dap 1 bias low
success: change accepted.
See Also
 display {ap | dap} config on page 277
set {ap | dap} blink Enables or disables LED blink mode on a MAP access point to make it
easy to identify.
When blink mode is enabled on an AP2750, the 11a LED blinks on and
off.
When blink mode is enabled on an AP3750, the health and radio LEDs
alternately blink green and amber.
When blink mode is enabled on an AP7250, the Radio LED flashes red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on an AP8250, the Radio LED flashes red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on an AP8750, both Radio LEDs flash red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on other models (MAP-xxx), the health and
radio LEDs alternately blink green and amber. By default, blink mode is
disabled.