Command Reference Guide
308 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
set dap auto mode Enables an WX switch’s template for automatic Distributed MAP
configuration.
Syntax —
set dap auto mode {enable | disable}
enable — Enables the MAP configuration template.
disable — Disables the MAP configuration template.
Defaults — The MAP configuration template is disabled by default.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — You must use the set dap auto command to create the
template before you can enable it.
Examples — The following command enables the template for
automatic Distributed MAP configuration:
WX1200# set dap auto mode enable
success: change accepted.
See Also
set dap auto on page 306
set dap auto radiotype on page 309
set {ap | dap} bias on page 310
set {ap | dap} blink on page 311
set {ap | dap} group on page 313
set {ap | dap} radio auto-tune max-power on page 317
set {ap | dap} radio auto-tune max- retransmissions on page 318
set {ap | dap} radio auto-tune min-client-rate on page 321
set {ap | dap} radio mode on page 323
set {ap | dap} radio radio-profile on page 324
set {ap | dap} upgrade-firmware on page 328